Middle rise car scissor lift

                                                                              Description

Mid-rise lifts, also sometimes referred to as scissors lifts，are basically like a big floor jack that pick up the entire car. Most mid-rise lifts, when fully extended, can pick a car up three feet, some a bit more.They lay flat on the floor, allowing a car to be parked over them，The hydraulic cylinders are driven by an electric pump.

                                                                                    Parameter

                                                                                            Benefit

• The scissor arms are made by the Q345 steel and go through the cold drawing process, which has good density and flexible. Others use the NO.45 Steel, and easy to break.

• Scissor arms shaft is Oil-free shaft and the cover was pressed and formed at one time leaves no gap and impurity matters.

• The platform is made of a whole steel plate with laser welding, the surface is more smooth and seamless

• Oil tube uses resin pressured hose that can hold up to 45 MPa which is greater than the 35 Mpa on the market.

• The tubing connection is upgraded to an aluminum alloy link and it is not easy to leak oil.

• The cylinder is configured with nut easy to assemble or disassemble

• The low voltage independent control station has good safety performance

• The hydraulic cylinder is synchronized with oil cylinder. It runs smoothly and safely.

• This machine has safety protection and explosion proof valve, and use imported high quality hydraulic electric device

Note: When the lift drops down below 300mm, you need to use the LOCK button to decline slowly, Do not press the DOWN key all the time. Otherwise, it is easy to cause extrusion of limit switch

                                                                                 Product Show